Se7en Error Checker
Where we differ from official Poseidon
Everywhere this app departs from Poseidon’s documents, it says so on the answer it affects. Here is the complete list, with the reason for each.
Differs from Poseidon’s documents
Step “Timeout…” is ours, not Poseidon’s. Their table lists 0 = Timeout as the code but gives no step for it; we put this first wherever the code is 0.
Differs from Poseidon’s documents
Corrected. Poseidon’s table gives test 18 (HUD red LED) the solenoid “click” step, test 19 (HUD green LED) the Battery LED step, and test 24 (O2 solenoid) the HUD LED step. We show the HUD LED step for 18 and 19, and the click step for 24.
Differs from Poseidon’s documents
Corrected. Poseidon’s table says “Replace Primary oxygen sensor” for these codes; they concern sensor #2, so we say Secondary.
Differs from Poseidon’s documents
Poseidon’s table lists no error code for this test and says to contact a Service Center. We say contact Poseidon Technical Support, for any code.
Differs from Poseidon’s documents
Spelling. Poseidon’s 2015 code sheet reads “Voltage is to low / to high”; the manuals read “too”, and so do we.
Differs from Poseidon’s documents
Reworded, same instruction. Poseidon’s tables read “moutpiece”, “FULLY”, “oxygen- and diluent tanks”, “reinstall Firmware”, “Ensure to confirm canister good / fraction via wet switch wet procedure”, and “Standard Response; Insert battery into the charger.” as one step. We say mouthpiece, fully, cylinders, firmware, “Confirm the canister / the gas fraction using the wet-switch procedure”, and give the charger step on its own after the Standard response.